Camp Creek Technologies
201602 MOV Backseat Relay
Firmware Update Instructions

NOTE: Settings and calibration remain unchanged using this update

1. Copy the image.hex file to a micro-SD card. The card used
   for logging may be used for this purpose.
   
2. Turn relay off.

3. Insert SD card in the slot on the side of the relay.

4. Press the [-] key. While holding it down, press the
   power key.
   
5. The screen should show "Bootloader v1.1, Press SETUP to pgm."

6. The [-] key may be released once the bootloader screen displays.

7. If you wish to cancel the update, press the STOP key.

8. Press SETUP. The screen will show Erasing for about 3 seconds
   followed by Programming for about 3 seconds.
   
9. Once complete, the normal relay startup screen will appear,
   identifying the version number.
   
10. The SD card may now be removed.




